![]() ![]() Check the WLAN > LAN & LAN > WLAN and make sure an any,any,allow rule is setup. All you should need to do it allow access in the firewall for the networks to talk. I can ping a statically assigned IP address from a wirleess client to a wired cient though. Guest Controls) yet seems to be causing similar isolation for clients. All interfaces must be port shielded in order to bridge the connection. Also, Wired client does not get DHCP lease from Sonicwall DHCP Server configured on WLAN, nor is it able to ping the gateway address on the Sonicwall. It isn't really related directly to client isolation or ACL itself (i.e. All my air port express stations are Static IP (one connects wirelessly to the router, the other to the Ap). After either unchecking this setting or adding in the MAC/clients I wanted to exempt from the multi-cast block, I was able to successfully ping between those clients. The issue: any wireless clients (Airport Express base stations) that connect wirelessly to the AP cannot be seen if I am connected wirelessly to the router and vice versa. ![]() "Block LAN to WLAN Multicast and Broadcast Data" was checked under the SSID/wireless network configuration. Guest policies are disabled in both the Guest settings and the AP profile settings, so I know it isn't Guest policies blocking it. It should be getting a 172.16.31.xxx IP address but it is getting a 169.254.41.248 IP address. I'm sure I'm missing something dumb, here, but I can't find anything in the firewall or routing of the configuration to block/deny connectivity. The Printer is connected to the SonicWall via WIFI but it is not getting a valid IP address. But pings to the Xbox live, or the RPi's timeout. pings to my DIY NAS work fine, as well as to our network laser printer and all network equipment. I can ping and SSH/SCP into any server or device wired into the network. Unified endpoint compliance: Cisco An圜onnect unifies endpoint posture and remediation across wired, wireless, and VPN environments for Cisco ISE. (No, they are not connected to wifi and wired at the same time.) I have asked SonicWall support of this but did not get any kind of answer or explanation. For SNMP v2c: s2w (IP address of controller) (community string) (OID string) (additional flags) Example: s2w 10.10.10. I have a full UniFi setup including: 3 AP Lites, 2 8-port switches, a USG, and the cloudkey.Įverything works well except I discovered last night while testing some Raspberry Pi projects that I can't ping, SSH, SCP, or otherwise connect to any other wireless device on the network. RE: airwaves not detecting clients 0 Kudos EMPLOYEE rgin Posted 08:38 PM Reply Reply Privately The AMP CLI has some aliases that assist with SNMP walks. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |